System Functional States; Standby On/Off Button; Settings; Set Temperature Setting - ZANOLLI CITIZEN Series Installation, Use And Maintenance Manual

_________________________________________________________________5. WORKING

5.2 System functional states

5.2.1 Standby
When on standby the panel is powered but no system function is enabled.
The general remote switch is disabled and the message OFF is displayed
on the set display
on the
and third figure, ½ second on, ½ second off).
All buttons on the panel are disabled except for the
and the key, pressure on which will bring the system to clock setting
mode (see "programming" section).
Pressing the
programmed is displayed on the set display
prior to switching the oven off is displayed on the
5.3

Settings

5.3.1 Set temperature setting

To set the SET temperature use the
baking temperature appears on the

5.3.2 Upper and lower element setting

Pressing the
on. Each time the button is pressed increases this value by 1 unit, up to a
maximum of 9 units. Further pressure returns the value to 0.
NB. Each unit on the two displays corresponds to 5 seconds element on
time. For the remaining units the elements remain off. The total duration of
the cycle is 45 seconds.
The on time of the two elements can be varied at any time, even during the
baking cycle. The upper elements during the first part of the cycle while the
lower ones come on during the second.
For example, setting the upper elements to 6 and the lower ones to 5 gives
the following result:
5
Upper
Lower
____________________________________________________________________________
17 CITIZEN 6 - 9/MC, CITIZEN 6+6 - 9+9/MC DIGITAL VERSION
on/off button
on the control panel along with the current time
display with flashing seconds dot (between the second
button, the system comes on, the last SET temperature
buttons varies the time the oven heating elements remain
10 15
ON
OFF
and
display.
20 25 30
button (system on)
, and the cycle used
display.
buttons until the desired
35 40
OFF
ON
45