Advanced Wireless Network Screen - ZyXEL Communications WX3310-B0 User Manual

Table 16 Networking > Wireless Network 5G/2.4G > Basic (continued)
LABEL
Channel
Selection
Current
Channel
Encryption
Pre-Shared Key
Group Key
Update Timer
Clone setting
from AP
connection
Apply
Cancel

10.5 Advanced Wireless Network Screen

Use this screen to select the advanced wireless settings for the WX3310.
Click Networking > Wireless Network 5G/2.4G > Advanced. The screen appears as shown.
Figure 32 Networking > Wireless Network 5G/2.4G > Advanced
Chapter 10 Wireless LAN
DESCRIPTION
Select the operating channel for the WX3310 and its wireless clients. The options vary depending
on the frequency band and the country you are in.
Select Auto and the WX3310 selects a channel automatically.
Select Smart Channel Selection (SCS), and the WX3310 decides to switch channels, monitors
several channels and chooses the one with higher capacity.
This displays the channel the WX3310 is currently using.
Select the data encryption method the WX3310 uses.
Select WPA2-AES or WPA2 + WPA (mixed mode) to add security on this wireless network. The
wireless clients which want to associate to this network must have same wireless security settings
as this device. Or you can select No Security to allow any client to associate this network without
authentication.
Enter the password that lets you connect to the WX3310. Your password should be in a string of
ASCII characters between 8 and 63 or hexadecimal characters between 8 and 64.
The Group Key Update Timer is the rate at which the WX3310 sends a new group key out to
clients.
Select this to copy the password and SSID from the wireless router or AP to the WX3310. Wireless
clients can then connect to the WX3310 using the same SSID and password as they did to
connect to the wireless router,
The check box is not available when the WX3310 is in AP mode.
Click Apply to save your changes back to the WX3310.
Click Cancel to reload the previous configuration for this screen.
WX3310-B0 User's Guide
57