Wireless Lan Advanced Screen - ZyXEL Communications WRE 2205 User Manual

The following table describes the labels in this menu.
Table 14 Network > Wireless LAN > MAC Address List
LABEL
Active
Set
MAC Address
Apply
Reset

6.6 Wireless LAN Advanced Screen

Use this screen to configure advanced wireless LAN parameters.
Click Network > Wireless LAN > Advanced. The screen appears as shown.
Figure 31 Network > Wireless LAN > Advanced
The following table describes the labels in this screen.
Table 15 Network > Wireless LAN > Advanced
LABEL
Wireless Advanced Setup
RTS/CTS
Threshold
Fragmentation
Threshold
Channel Width
WRE2205 User's Guide
DESCRIPTION
Select this to enable MAC address filtering.
This is the index number of the MAC address.
Enter the MAC addresses of the wireless station that are allowed access to the WRE2205 in
these address fields. Enter the MAC addresses in a valid MAC address format, that is, six
hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Click Apply to save your changes back to the WRE2205.
Click Reset to reload the previous configuration for this screen.
DESCRIPTION
Data with its frame size larger than this value will perform the RTS (Request To Send)/
CTS (Clear To Send) handshake.
Enter a value between 0 and 2347.
The threshold (number of bytes) for the fragmentation boundary for directed messages.
It is the maximum data fragment size that can be sent. Enter an even number between
256 and 2346.
Select whether the WRE2205 uses a wireless channel width of 20MHz or Auto 20/40MHz.
A standard 20MHz channel offers transfer speeds of up to 150Mbps whereas a 40MHz
channel uses two standard channels and offers speeds of up to 300 Mbps. Because not all
devices support 40MHz channels, select Auto 20/40MHz to allow the WRE2205 to adjust
the channel bandwidth automatically.
Chapter 6 Wireless LAN
45