Page 1
Manual Index BARNES BARNES ® INSTALLATION and OPERATION MANUAL Diaphragm Pumps Models: 44CDD6 44CDG10 DISCONTINUED Parts NOT available IMPORTANT! Read all instructions in this manual before operating pump. As a result of Crane Pumps & Systems, Inc., constant product improvement program, product changes may occur.
California to cause cancer, birth defects or other reproductive harm. Other brand and product names are trademarks or registered trademarks of their respective holders. ® Barnes is a registered trademark of Crane Pumps & Systems, Inc 1987, 1997, 1998, 2002, 4/06, 9/06 Alteration Rights Reserved...
SAFETY FIRST! Please Read This Before Installing Or Operating Pump. This information is provided for SAFETY and to PREVENT Always wear eye protection when working on pumps. EQUIPMENT PROBLEMS. To help recognize this information, observe the following symbols: Make sure lifting handles are securely fastened each IMPORTANT! Warns about hazards that can result time before lifting.
B-3) Storage: and speed up priming. Short Term - Barnes Pumps are manufactured for effi cient Pump speed can be regulated with throttle control on performance following long inoperative periods in storage.
C. Manually rotate the drive such that the connecting rod SECTION: F REPLACEMENT PARTS F-1 ORDERING REPLACEMENT PARTS: assembly moves up and off the diaphragm. When ordering replacement parts, ALWAYS furnish the D. Remove the diaphragm from the diaphragm bottom following information: and install a new one onto the studs of the diaphragm bottom.
® BARNES BARNES Limited Warranty We warrant to our immediate customer and to the ultimate consumer that products of our manufacture will be free of defects in material and workmanship under normal use and service for the following time periods, when installed and maintained in accordance with our instructions.
START-UP REPORT FOR ENGINE DRIVEN PUMPS This form is designed to provide assurance that customer service and a quality product are the number one priority with Crane Pumps & Systems, Inc. Please fi ll out the following questions as completely and accurate as possible.
Page 14
I have received the above information (Name of Operator): Name of Company: Date: I Certify this report to be accurate (Name of Start-Up Person) Employed By: Date: Date and Time of Start-Up Present at Start-Up: ( ) Engineer: ( ) Operator: ( ) Contractor: ( ) Other: TO BE FILLED OUT BY FACTORY...
IMPORTANT! WARRANTY REGISTRATION Your product is covered by the enclosed Warranty. Complete the Warranty Registration Form and return to Crane Pumps & Systems, Inc. Warranty Service Group If you have a claim under the provision of the warranty, contact your local Crane Pumps &...
Page 16
FOLD HERE AND TAPE, DO NOT STAPLE PLACE STAMP HERE CRANE PUMPS & SYSTEMS, INC. WARRANTY SERVICE GROUP 420 THIRD STREET PIQUA, OHIO 45356 - U.S.A.