Page 1
BARNES ® INSTALLATION and OPERATION MANUAL Centrifugal Pumps Model: 4030HCU IMPORTANT! Read all instructions in this manual before operating pump. As a result of Crane Pumps & Systems, Inc., constant product improvement program, product changes may occur. As such Crane Pumps & Systems reserves the right to change product without prior written notifi...
START-UP REPORT ..................13 - 15 WARRANTY REGISTRATION Other brand and product names are trademarks or registered trademarks of their respective holders. ® Barnes is a registered trademark of Crane Pumps & Systems, Inc 1984, 1997, 1998, 2002, 10/04, 1/06, 8/06 Alteration Rights Reserved...
SAFETY FIRST! Please Read This Before Installing Or Operating Pump. This information is provided for SAFETY and to PREVENT Always wear eye protection when working on pumps. EQUIPMENT PROBLEMS. To help recognize this information, observe the following symbols: Make sure lifting handles are securely fastened each IMPORTANT! Warns about hazards that can result time before lifting.
Congratulations! You are the owner of one of the fi nest matter from being drawn into the impeller. The pumps on the market today. Barnes ® Pumps are products strainer should be cleaned regularly to insure full fl ow. engineered and manufactured of high quality components.
SECTION: F REPLACEMENT PARTS CAUTION! - Handle seal parts with extreme care. DO NOT scratch or mar lapped faces. F-1 ORDERING REPLACEMENT PARTS: When ordering replacement parts, ALWAYS furnish the following information: Replace seal plate (15) onto pedestal (17). Lightly oil and replace shaft sleeve (14) and cup of stationary member 1.
TROUBLE SHOOTING CAUTION ! Always disconnect the pump from the electrical power source before handling. If the system fails to operate properly, carefully read instructions and perform maintenance recommendations. SYMPTOM POSSIBLE CAUSE(S) Little or no discharge 1. Casing not fi lled with water 1.
PARTS KIT Seal Kit ....P/N: 083562 (‡) 6, 12, 13, 14, 16. PARTS LIST Model: 4030HCU P/N: 059459 ITEM QTY. PART No. DESCRIPTION 059452 Volute 016409 Stud 1/2-13 x 2.00” Lg 002608 Lockwasher 1/2” 15-6-6 Hex Nut 1/2-13, Zp...
Page 11
Limited 24 Month Warranty Crane Pumps & Systems warrants that products of our manufacture will be free of defects in material and workmanship under normal use and service for twenty-four (24) months after manufacture date, when installed and maintained in accordance with our instructions.This warranty gives you specifi c legal rights, and there may also be other rights which vary from state to state.
IMPORTANT! WARRANTY REGISTRATION Your product is covered by the enclosed Warranty. To complete the Warranty Registration Form go to: http://www.cranepumps.com/ProductRegistration/ If you have a claim under the provision of the warranty, contact your local Crane Pumps & Systems, Inc. Distributor. RETURNED GOODS RETURN OF MERCHANDISE REQUIRES A “RETURNED GOODS AUTHORIZATION”.