Sediment Filter Installation - Pentair PC600-P Quick Start Manual

SEDIMENT FILTER INSTALLATION

Note
Sediment filter position is at the discretion of your professional installer. As a general guideline, the sediment pre filter is
typically installed in the "pre" position (as shown above) for well-water applications. For city water applications, the sediment
filter is typically installed in the "post" position after the Carbon Water Filter System Tank.
Sediment Filter Cover
Blue Filter Housing
Part 1
1. Unscrew the cover from the blue filter housing.
2. Remove the plastic covering from the sediment filter.
3. Place the sediment filter onto the stand pipe in the blue filter housing and set aside.
Inlet Water
Supply
Inlet Water
Supply
Part 2
1. Shut off the water.
2. Attach the filter cover to the mounting bracket using the supplied bolt head screws and washers. Make sure to properly
orientate the IN and OUT to match your flow pattern.
3. Attach the mounting bracket to the wall using the supplied phillips head screws.
4. Hand tighten the blue filter housing and then, using the supplied filter wrench, lightly snug the housing making sure not to
over-tighten (counterclockwise).
5. Determine the size of your inlet water supply line.
Mounting
Bracket
Mounting
Bracket
Blue Filter Housing
Blue Filter Housing
WATER SOFTENER ALTERNATIVE WITH NATURSOFT® SALT-FREE TECHNOLOGY
WATER SOFTENER ALTERNATIVE WITH NATURSOFT® SALT-FREE TECHNOLOGY
Sediment Filter
O-Ring x2
Stand Pipe
Top View Filter
Top View Filter
WHOLE HOUSE WATER FILTER SYSTEM
• 7
• 7
• 7