Filter Cartridge Replacement; Troubleshooting - Pentair LR-BB50 Installation And Operation Manual

Heavy duty water filtration system
Hide thumbs Also See for LR-BB50:
Table of Contents

Advertisement

Available languages

Available languages

FILTER CARTRIDGE REPLACEMENT

The life of the cartridge depends on the water volume used and the
substances in the water. Normally the cartridge should be changed at
intervals of three to six months or less. Replace the cartridge sooner
if the water pressure at the faucet begins to drop noticeably or if you
1. (A)
1/2 turn until it comes to a stop.
NOTE:
(B)
Remove bottom of housing by unscrewing.
2. Locate and remove large O-ring
aside. Discard used cartridge
and bottom of housing with non-abrasive sponge or cloth. Rinse
thoroughly. Lubricate O-ring
NOTE: This step is important to ensure proper housing seal.
Make sure O-ring is seated level in the groove.
(D)
Insert new cartridge
3. (A)
Screw bottom of housing onto the cap and hand-tighten until
snug.
DO NOT OVER-TIGHTEN. Make certain cap standpipe slips into
cartridge.
(B)
Slowly turn handle on housing 1/2 turn counter-clockwise
relief button to release trapped air. Flush cartridge for 15
minutes. Check for leaks before leaving installation.

TROUBLESHOOTING

Leaks . . .
1. Turn off water supply and press the red pressure relief button.
Remove bottom of housing.
2. Clean O-ring and O-ring groove (located directly beneath threads of
housing). Inspect O-ring for defects. Replace if needed. Lubricate
O-ring with clean silicone and replace securely into groove. Screw
bottom of housing onto cap and hand-tighten until snug. DO NOT
OVER-TIGHTEN.
3. Turn on water supply. Depress red pressure relief button to release
trapped air. If leaks persist, or if there are other leaks on the system,
turn off water supply. Call Customer Service at 800-279-9404.
1. Turn off water supply. Depress red pressure relief button to release
2. Turn on water supply. If leaks persist, or if there are other leaks on
system, turn off water supply.
Call Customer Service at: 800-279-9404.
6
(A)
, wipe clean of lubricant and set
(B)
. Rinse out bottom of housing and
(C)
with clean silicone. Insert O-ring
over standpipe in bottom of housing.
(C)
Depress red pressure
1
2
3
262.634.2386 | greatlakesintl.com
A
B
A
C
B
D
B
C
A

Advertisement

Table of Contents
loading

Table of Contents