Bypass Valve Operations - Pentair PC600-P Quick Start Manual

BYPASS VALVE OPERATIONS

Figure A shows the system "in service" which
allows water to flow in and out of the tank. In this
position the system would be considered ON.
Figure B shows the system "in bypass" which will
direct water straight to the home without going
in and out of the tank. In this position the system
would be considered OFF.
COMPLETE THE INSTALLATION
1. Turn on main water supply and check for leaks.
2. Peel off the protective plastic wrap from the stainless steel tank jacket(s)
3. Add the Pentair logo sticker(s) in the desired location on the tank.
4. Wax stainless steel tank jacket(s) with wax provided (or any other non-abrasive auto wax) a minimum of 1-2 times per year or as
needed based on the installed environment.
CAUTION
Avoid high flow rates such as bathtub, utility sinks, hose bibs, multi-headed showers, body sprayers, or anything that is considered
high flow for the first 72 hours to avoid flow restrictions caused by carbon blockage of the top basket inside the carbon tank.
CAUTION
Carbon dust may be released into the water lines of the house/building during the first few days of water use after carbon tank
installation. The carbon dust is harmless, but may give the water a gray appearance that should diminish within a week or 10 days
depending on water use.
In Service
In Service
Figure A
Figure A
In Bypass
In Bypass
Figure B
Figure B
WHOLE HOUSE WATER FILTER SYSTEM • 9