Carbon Water Filter System Tank Installation - Pentair PC600-P Quick Start Manual

CARBON WATER FILTER SYSTEM TANK INSTALLATION

1. Level the Carbon Water Filter System Tank.
WATER SOFTENER ALTERNATIVE TANK INSTALLATION
Note
See "Troubleshooting" section on tips for leveling the tank.
If the tank is not level, lift the tank straight up 6 inches and tap it on the ground until the tank stands vertical.
The bottom of the tank is round and the boot allows the tank to stand upright.
2. Determine the size and material of your incoming water supply line and choose the appropriate plumbing required to adapt
to the 1" male NPT Assembly.
Note
Visit Pentair.com/homewater to view our full line of installation kits.
CAUTION
Do not over-tighten any of the fittings during installation. Shut Off Valves
Note
The fitting below is designed with a ¼" give to allow for proper pipe alignment. It will not leak and is intended to
have some flexibility.
Part Description
1" Plastic Male NPT Assembly:
V3007-04 WS1 Fitting 1" Plastic Male NPT Front View
Assembly (2): O-Rings (2), Split Rings (2),
and Connectors (2)
3. Install the fittings into the INLET and OUTLET sides of the bypass valve. Follow the diagram supplied with the fitting.
4. Connect the incoming water supply from the sediment filter to the fitting on the INLET side of the bypass valve.
5. Connect the outgoing water supply to the OUTLET side of the bypass valve.
8 • WHOLE HOUSE WATER FILTER SYSTEM
Incoming
Carbon Water
Filter System
Top View
Bypass
Sediment Filter
Fluoride
Filter
PVC Fitting*
Water
Supply
Water to Home
Split Ring
Qty.
1
bag
Outgoing
W ater to
House
1" NPT Assembly
Bypass Valve
*Customer supplied;
choose appropriate connection
Quick Connect Nut
O-Ring