Venting Methods
IMPORTANT:
•
NEVER exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling, attics or
garages. All exhaust must be ducted to the outside.
•
Use metal/aluminum duct work only.
•
Fasten all connections with sheet metal screws and tape all joints with certified Silver Tape or Duct Tape.
•
Use caulking to seal exterior wall or roof opening around the cap.
:
Venting Methods
•
Vent work can terminate either through the roof or wall. To vent through a wall, a 90° elbow may be needed.
•
This range hood is factory set for vertical venting using a rectangular vent adapter but can be converted to
horizontal venting by swapping the vent adapter on top with a rectangular vent adapter behind the range
hood as shown below:
Horizontal wall venting
Type 1:
3-1/4 x 10-inch rectangular vent
adapter on the rear or top of the
hood (with an elbow if on the top)
Option 1:
Side wall cap
Option 2:
Vertical roof venting
Roof cap
Type 2:
3-1/4 x 10-inch rectangular vent
adapter on top of the range hood.
Page 7