Table of Contents
Advertisement
5
Using the system
5.1
Basic features and operation
The dash-mounted Adaptive Dial Controller is designed for intuitive operation. The
function of each interface feature is described below.
System
Displays the status of the trim tab system.
Status
Indicator
Steady green
Steady magenta
Steady lime green
Flashing blue
Flashing cyan
Steady blue
Flashing yellow
Flashing red
Shows the position of port and starboard tabs. At full retraction a
Tab
Position
single LED is shown at the top. As the tabs are extended the LEDs will
Indicator
illuminate to show the tab position.
LEDs
Bow
Lowers both tabs simultaneously, causing the bow to drop. Press and
Down
release to move both tabs a preset increment, or press and hold until
the desired pitch is achieved. To enable fine control, the actuator
speed is reduced for the first second the button is held, after which
the actuators move at full speed for larger adjustments.
Bow
Raises both tabs simultaneously, causing the bow to rise. Press and
Up
release to move both tabs a preset increment, or press and hold until
the desired pitch is achieved. To enable fine control, the actuator
speed is reduced for the first second the button is held, after which
the actuators move at full speed for larger adjustments.
Control
Rolls the boat in the direction of rotation. Rotating the dial to starboard
Dial
(clockwise) will cause the port tab to lower and the starboard tab to
raise, causing the boat to roll to starboard. Turning the dial to port
(counterclockwise) will have the opposite effect.
6
Optimus Adaptive Trim Tab System | Adaptive Trim Tab System
System is ready
Holeshot mode is activated, based on SOG
Holeshot mode is activated, based on RPM
System is in LED brightness adjustment mode
The system has memorized the favorite position
Tabs retracted automatically
Controller has a non-critical fault (see section 6)
Controller has a critical fault (see section 6)
EN
Advertisement
Table of Contents
