Table of Contents
Advertisement
WARNING!
If sea conditions have changed since the last Adaptive Cruising Favorite
setpoint was stored, the trim position may be unsuitable, and could
potentially put the boat in a poor attitude for the conditions. Trim the
tabs manually in this case. Always use your best judgment before
activating Holeshot mode.
NOTE: Planing time limit
When RPM is used to control the tab deployment (i.e. no SOG source),
there is a time limit between activation and when you must initiate the
holeshot (by throttling up). The default limit is 15 seconds.
NOTE: Holeshot performance
The performance of holeshot mode is sensitive to tab size, system
tuning, and throttle application. If holeshot performance is unsatisfactory,
contact your dealer for assistance.
NOTE
If you cannot activate Holeshot mode:
• Your boat may not have an engine RPM or GPS speed-over-ground
source.
• Holeshot mode may be disabled. See the description of the Favorite
button in section 5.1.
• Check that at least one engine is running, no engines are in reverse
gear, and that an Optimus joystick (if equipped) is not active.
NOTE: Holeshot automatic deactivation
If Holeshot mode is activated, it will automatically deactivate when:
• all engines are switched off
• any engine is shifted into reverse
• an Optimus joystick is activated
Holeshot mode will automatically reactivate when at least one engine is
running, no engines are in reverse, and the joystick is not active.
10
Optimus Adaptive Trim Tab System | Adaptive Trim Tab System
EN
Advertisement
Table of Contents
