Table of Contents
Advertisement
Optimus Adaptive Trim Tab System | Adaptive Trim Tab System
6.2
Troubleshooting
Problem
The system status
LED is off.
The system status LED
is flashing yellow.
The system status
LED is flashing red.
Tab position
indicators are solid.
The system status LED
is flashing red. One
or both tab position
indicators are flashing.
Holeshot mode
won't enable.
Holeshot
performance
is poor.
EN
Cause
The ignition is not on.
Circuit breaker or
fuse has tripped.
The controller is not
receiving a wakeup
signal.
Holeshot mode is
activated, but the
speed source is
missing.
If one or both tab
position indicators
are off, the tab(s)
have failed to home
correctly.
Battery voltage is
too low or too high.
Tab(s) with blinking
position indicators are
not making position.
Your boat is not
equipped with a
speed source.
The boat builder or
system installer has
deactivated
this system.
Sea conditions are
different than the
mode was tuned for.
Holeshot settings have
not been optimized
for your boat.
Remedy
Turn on the ignition.
Reset breaker or replace fuse.
Optimus Adaptive Trim Tab System:
if the CANtrak is on, check the
connections in the CAN2 network.
If the CANtrak is not on, check the
Optimus EPS ignition sensing wire.
Adaptive trim tab system: check the
ignition sensing wire.
Multi-engine boats: check that all
engines are running.
Contact your dealer.
Try pressing the Home button again.
Check that nothing is physically
preventing the tabs from moving to
the home position.
Contact your dealer.
Check battery voltage.
Check that nothing is physically
preventing the tabs from moving.
If there is no obstruction, contact
your dealer.
Contact your dealer.
Contact your dealer.
Adjust trim manually.
Contact your dealer.
13
Advertisement
Table of Contents
