Table of Contents
Advertisement
HOW TO USE HEATING FUNCTION
暖 氣 功 能 的使用方法
Notice
提示事項
1. Hot startup function: After the product starts up in the strong heating mode when the
temperature in the bathroom is lower than 20 °C, it enters the hot startup status to avoid
blowing of cold air, and the fan runs at a low speed. When the temperature in the bathroom
reaches 20 °C or above or after running for 60 seconds, the hot startup status stops and the
fan runs at a high speed.
熱啟動功能：當浴室溫度低於20 °C時，以暖氣強檔模式啟動後，為避免冷風吹出，產品進入熱啟動狀態，
扇葉以低速運轉，待浴室溫度達至20 °C以上或經過60秒後，熱啟動狀態停止，扇葉以高速運轉。
2.
Heater may stop heating when temperature in bathroom is up to required degree, and may
restart heating as the temperature in bathroom cools down.
當 浴室內 溫 度 上 升 到 一 定 程度 時， 加熱 器 停止 工作 ，待溫度下降到一定程度後，加熱器重新開始工作。
Use when you feel cold in a bath
Before taking a bath, start the heating function to warm the bathroom
beforehand.
在沐浴前開暖氣功能，可提前將浴室升溫。
1
Press the
button to start the heating mode at the HI.
It will switch to the LO. mode if you press this button again.
按
按 鈕， 暖氣 模 式以 強檔開始運轉，再按一次將切換為弱檔。
The default [FIXED] is recommended. The air direction can be reset
during operation.
推薦使用出廠設置狀態[固定]，運轉中也可以重新設置風向。
The default [SPOT] is recommended. The air type can be reset during
operation.
推 薦使 用出 廠設 置狀 態[集中]，運轉中也可以重新設置風種。
The default setting is 15 minutes. You can adjust it as required.
出 廠設 置狀 態為15分 鐘，用戶可根據需要自行調整。
2
This product will stop automatically when the set time is up.
運轉完所設置時間後，本機會自動停止。
3
To stop midway in running,pressthe button.
如需在運轉途中停止，請按
In the heating mode running for 30 seconds above, press the
button to stop the heater. The fan will stop running after a delay
of 20 seconds.
若在暖氣模式運轉30秒以上，按
扇葉將延遲20秒停止運轉。
在 浴 室中感 到 冷時使 用
(Initial settings)
(初始設置)
HI
LO
強
弱
按鈕。
按鈕後，為使加熱器冷卻，
21
Advertisement
Table of Contents
