Table of Contents
Advertisement
HOW TO INSTALL
安裝方法
Use one 4 x 8 self-tapping screw to fix the
adapter. Be sure to fix this screw because it
can prevent the main body from falling off
the ceiling board.
用 顆
1
4x8
的自攻螺絲將
此螺絲能起到防止機體脫落的作用，請務必安裝
After completion of the installation work, be
9
sure the condition between the main body and
the adapter is proper. It can be checked from
the inspection hole.
安裝完成後，請務必從點檢口確認機體與出風口接頭
的安裝是否到位。
Notice
提示事 項
If the body and the adapter are not tightly attached, it will cause
air leakage and affect the function of preventing the body from
falling off in step
如機體 與 出風口接 頭 未貼緊，會導致 漏風， 及影響
1-3
Main body installation
Method 3 Ceiling board has not been installed
1
Positioning and installing the suspenders.
吊桿的定位安裝。
(1)
Paste the installation cardboard provided on the
position where the main body is intended to be
installed.
將產品附帶的安裝用紙板，粘貼在機體預定安裝的位置。
(2)
Fix the suspenders on the ceiling according to the
location holes as shown in the installation cardboard.
按照安裝用紙板所示的吊桿固定位置，將吊桿固定於水泥板上。
出風口接頭
牢固地固定
.
8
，
Cross screwdriver
。
(not longer than 150 mm)
(長度不大於150 mm)
8
中防止機體脫落的作用。
機體的安裝
方法三 未裝天花板吊裝
Unit:mm
單位：mm
Ceiling
水泥板
Suspender
吊桿
Self-tapping
screws
自攻螺絲
十字螺絲刀
Installationcardboard
安裝用紙板
4 x8
4x8
Gap
縫隙
13
Advertisement
Table of Contents
