HOW TO INSTALL
安裝方法
2. Installing louver assembly
Remove the filter assembly from the louver assembly.
將 過濾網 組 合 從 面 板 組 合拆 除 。
Openthe frontpanel of the louver assembly
2
by lifting it upward.
將 雙層面 板 的 前 面 板打 開 ,向 上掀 即可 打開 。
Hang the louver assembly into the hook
on the main body.
將 面板組 合 掛 入 機 體 上 的掛 鉤 。
Insert the screw cover with a slotted screwdriver
and pry the screw cover outward. Fix the louver
assembly to the main body with four M4×8 machine
screws provided in accessory packaging.
用一 字 螺 絲 刀 插 入 螺 絲 蓋 的 縫隙 ,往 外撬 開螺 絲蓋 。
使用附 件 包 所 提 供 的4顆M4× 8機械螺絲將面板組合
固 定於 機 體。
Notice
提示事 項
Please be careful not to scratch the
請注意 不 要 刮 花 面 板 組 合 。
Covering the screw cover, fixthefrontpaneloflouver
assemblyto louverholderbyusingthetwo machine
screw M4×10.(Please use a screwdriver which metal
rod is longer than 180 mm )
將撬開的 螺 絲 蓋 重 新 蓋好 ,使
板組合 的 前 面 板 固 定 於面 板底 座
180 mm 的 十 字 螺 絲 刀 )
CAUTION
■
Be sure to fasten the front louver and the
louver holder with screws.
務必用螺絲緊固前面板與面板底座。
Otherwise ,the front panel may fall and
cause injury.
否 則 前 面 板 可 能 會掉 落導 致受 傷。
Install the filter assembly back into the louver assembly.
將 過濾網 組 合 重 新 安 裝 回面 板 組合 。
Notice
提 示事項
1 After finishing installation, make sure that the baffle
.
plate holder protrudes from the louver assembly by
approximately
1
mm.
assembly to be deformed
安 裝完成 後 , 請 確 保 導 風板 支 架突 出面 板組 合約1 mm。
否 則可能 導 致 面 板 組 合 變 形。
2.Make sure that the
in place, otherwise foreign matter such as dust and hair may enter.
請確保面板組合及過濾網安裝到位,否則可能導致灰塵、毛髮等異物進入。
面 板 組合安 裝
louverassembly
用2顆M4×10機 械
。
(請 使用 金 屬桿 長大於
注 意
Otherwise it may cause the filter
louver assembly
and filter
.
Machine screw M4×10
螺 絲
,
將面
Baffle plate holder
導風板支架
About 1 mm
約1 mm
assembly
are installed
Liftupward
掀開向上
Main body
hook
機體掛鉤
Machine screw
M4×8
機械螺絲
M4×8
機械螺絲M4×10
Screw cover
螺絲蓋
Louver assembly
面板組合
15