Korg Soundlink DRS OASYS PCI User Manual page 74

Mixer
Note that Solo affects only the mixer, and does not affect audio sent directly to
the audio outputs from a digital audio program.
Solo responds to controller #90 on the selected MIDI channel. 0 is off (not soloed),
and any value between 1 and 127 is on (soloed).
Output
Master, Analog L-R, S/PDIF L-R, ADAT 1-2, ADAT 3-4, ADAT 5-6, ADAT 7-8.
This selects the Output Bus to which the mixer channel will be routed.
If Master is selected, the Mixer Channel will go to the Output Bus designated as
the Master Output; if the Master Output selection is changed, the Mixer Channel
will automatically be re-routed to the new Master.
For more information, see "Output Busses," on page 78.
Insert Effects
Each mixer channel has four slots for insert effects. The effects are applied before
the channel volume (pre-fader), and are in series from top to bottom; effect 1 is
first, and effect 4 is last.
Insert Effects Routing
Input Insert 1
To select an Effect:
1.
For more information on using the Catalog, please see the section titled "Catalog"
on page 108.
If no Effect is selected for an insert slot, the signal will pass through unaltered, and
the slot will simply show "(none)."
You can copy Effects from one slot to another by using drag-and-drop, or by using
the Edit menu's cut, copy, and paste commands.
To delete an Effect, use the Edit menu's cut command, or press the Delete key.
Editing Effects
To edit the Effect's parameters, double-click on the Effect name. This will bring up
the Effect's Control Panel, as described on page 92.
70
Insert 2
Drag an Effect from the Catalog onto the desired insert slot.
or
Select an Effect slot and then double-click the name of the Effect in the
Catalog.
Insert 3 Insert 4
Reference
Volume
OASYS PCI