Korg Soundlink DRS OASYS PCI User Manual page 49

Using the OASYS PCI
Analog L-R, S/PDIF L-R, ADAT 1-2, ADAT 3-4, ADAT 5-6, and
ADAT 7-8
These selections allow you to route audio directly to the OASYS PCI outputs,
without passing through the mixer. For more information, see "Routing audio
directly to the OASYS PCI outputs," below.
Streams 1-8
Streams 1-8 allow you to route the signal into an OASYS PCI mixer channel or send
bus. For more information, see "Processing audio through OASYS PCI effects,
using Streams" and "Routing audio to an OASYS PCI Send Bus, using Streams,"
below.
Processing audio through OASYS PCI effects, using Streams
You can route up to 8 channels of audio from the ASIO or MME digital audio
program to the OASYS PCI's mixer channels, for processing through effects. To do
this:
1.
The OASYS PCI's mixer channels will accept either stereo or mono signals. If the
digital audio program offers only stereo outputs, use hard-panning to send
discrete, mono signals to separate OASYS PCI mixer channels.
2.
3.
The audio will now be routed to the OASYS PCI mixer channel.
4.
You can also send audio directly to an OASYS PCI Send Bus, as described below.
Finally, you can record the processed audio back into your audio program, as
described in "Recording OASYS PCI synthesizers and effects," below.
Routing audio to an OASYS PCI Send Bus, using Streams
You can route up to 4 channels of audio from the ASIO or MME digital audio
program to the OASYS PCI's Send Busses. The audio will be merged into the Send
Bus along with any audio sent from OASYS PCI Mixer Channels. Using this
feature, OASYS PCI Mixer Channels can share send effects with the audio program.
To do this:
1.
Many programs allow audio channels to "send" directly to an output. In this case,
just set the channel to send to the desired Stream.
OASYS PCI
In the audio program, assign the audio channel's output to a Stream (1-8).
In the OASYS PCI Editor, set the mixer channel's Input Type to Stream.
Set the mixer channel's input to the Stream you selected in Step 1.
Use Insert, Send, and Output Bus effects on the channels, as desired, just as
you would for internal OASYS PCI synths or audio inputs.
In the audio program, assign the audio channel or send bus's output to a
Stream (1-8).
Using Audio Programs
45