Korg Soundlink DRS OASYS PCI User Manual page 123

Reference
Printer. The OASYS PCI will send and receive MIDI from the Printer port.
Interface Speed (MacOS)
This parameter only applies when the MIDI System parameter, above, is set to
Serial.
1x. This is the normal MIDI interface speed.
Fast. Use this setting with multi-port interfaces (MIDI TimePiece, Studio 4/5/128,
etc.) set to "fast" mode.
Global pitch bend range
Half Step, Whole Step, Min. 3rd, Maj. 3rd, Perfect 4th, Dim. 5th, Perfect 5th, Min.
6th, Maj. 6th, Min. 7th, Maj. 7th, Octave. This range is used for all Patches in
which the Pitch Bend range is set to Global.
Tempo Delay Threshold
This controls the hysteresis for MIDI tempo delays. To compensate for uneven
MIDI clock messages (which are quite common), the OASYS PCI suppresses small
tempo changes for controlling delay times. Once a tempo is established, OASYS
PCI will not change the delay tempo until it receives a certain number of clocks at a
new tempo. This parameter sets the number of consecutive MIDI clock commands
which must be received before changing the tempo.
Send MIDI Parameter Change Messages
On/Off. When this parameter is enabled, editing any parameter in the Effect and
Patch Control Panels will send out a corresponding System Exclusive Parameter
Change message.
You can automate parameter changes by recording these messages into a MIDI
sequencer, and then playing them back into the OASYS PCI. To receive the
messages, the Receive MIDI Parameter Change Messages parameter, described
below, must also be enabled.
For more information, please see "MIDI System Exclusive Format" on page 139.
Receive MIDI Parameter Change Messages
On/Off. When this parameter is enabled, System Exclusive Parameter Change
messages can be used to control all Patch and Effect Control Panel parameters. For
more information, see "Send MIDI Parameter Change Messages," above.
Update Control Panel From MIDI
This only applies when Receive MIDI Parameter Change Messages, described
above, is enabled.
On. When MIDI Parameter Changes Update Control Panel is enabled, incoming
System Exclusive Parameter Change messages will move the knobs, sliders, etc. on
the Control Panel, as well as updating the parameter values.
OASYS PCI
Preferences
119