Using A Browser To Control The Projector - Epson PowerLite 826W+ User Manual

5. Enter up to two IP addresses for notification.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used: 127.x.x.x,
224.0.0.0 to 255.255.255.255 (where x is a number from 0 to
255).
6. For
Priority Gateway
85+/825+/826W+ only).
7. If your network environment uses an AMX controller, select
to allow the projector to be detected by AMX Device Discovery.

Using a Browser to Control the Projector

You can use a standard web browser to monitor and control the
projector through the network.
1. Make sure that the projector is set up for your network, as
described on page 64. (Standby Mode in the Extended menu
should be set to
Communication On
standby mode.) When using a browser to access the projector, you
cannot connect through a proxy server.
2. Open your web browser and enter the IP address of the projector
you want to monitor in the browser window.
If you're not sure what the address of the projector is, turn the
projector on and select
Info.-Wireless LAN
the Network menu to display the IP address of the projector. Do
not enter leading zeroes.
, select or
Wired Wireless
to monitor the projector in
Net. Info.-Wired LAN
(PowerLite 85+/825+/826W+ only) from
(PowerLite
On
or
Net.
Using the Projector on a Network
97