Assembly; Standard Ceiling Mounting - HAMPTON BAY GLENDALE AG524I-BN Use And Care Manual

Assembly — Standard Ceiling Mounting
1
Preparing the Canopy
□
Remove the two non-slotted canopy mounting screws
with lock washers (DD) from the canopy (B), and
loosen the slotted canopy mounting screws with lock
washers (DD) on the canopy (B).
□
Remove the canopy (B) from the mounting bracket (A)
by turning the canopy (B) counter-clockwise.
DD
A
3
Assembling the Fan
WARNING: Failure to properly install the cotter pin (
could result in the fan becoming loose and possibly falling.
NOTE: If a longer downrod is needed (not included), take
out the screw located in the hanger ball, lower the hanger
ball, and remove the pin. Remove all three pieces from the
downrod and assemble them onto the longer downrod before
proceeding to step 3.
□
Route the wires through the canopy (B) and then
through the hanger ball/downrod assembly (D).
□
Align the holes at the bottom of the hanger
ball/downrod assembly (D) with the holes in the
collar on top of the fan motor assembly (E). Carefully
insert the clevis pin (EE) through the holes in the
collar and the hanger ball/downrod assembly (D). Be
careful not to jam the clevis pin (EE) against the
wiring inside the hanger ball/downrod assembly (D).
□
Insert the cotter pin (FF) through the hole near the
end of the clevis pin (EE) until it snaps into the locked
position.
2
□
DD
EE
B
□
FF)
EE
E
9
Preparing the Motor
Remove the cotter pin (FF) and clevis pin (EE), then
loosen the two collar set screws (GG) from the motor
collar.
Firmly tighten the two collar set screws (GG) on top of
the fan motor assembly (E).
FF
GG
GG
D
B
FF
GG