Assembly - HAMPTON BAY TITAN 52 Use And Care Manual

Assembly - Hanging the Fan (continued)
4
Installing the receiver
WARNING: To reduce the risk of fire or electric shock,remember
to disconnect power. The electrical wiring must meet all local
and national electrical code requirements.The electrical source
and fan must be 110/120 volt, 60Hz. Do not use this product
in conjunction with any variable wallcontrol. Incorrect wire
connection can damage this receiver.
CAUTION: If other fan wires are a different color, have this
unit installed by a licensed electrician.
□
Position the house supply wires (AAA) to one side of the slide-
on mounting bracket (A); position the fan wires (BBB) to the
opposite side.
□
Insert the narrow end of the receiver (H) (as shown, flat side
towards the ceiling) into the slide-on mounting bracket until it
rests on top of the ball/downrod assembly.
A
B
H
AAA
5
Wiring the receiver to the
household wiring
WARNING: To avoid possible electrical shock, turn the
electricity off at the main fuse box before wiring. If you
feel you do not have enough electrical wiring knowledge or
experience, contact a licensed electrician.
IMPORTANT: Use the plastic wire connecting nuts (CC)
supplied with your fan. Secure the connectors with electrical
tape and ensure there are no loose strands or connections.
NOTE: If your house wiring does not have a red switch wire,
please connect the receiver black wire and receiver red wire
to the house black wire and secure using a plastic wire nut.
NOTE: 3-wire receiver will enable independent control of
fan and light at the wall switch if house wiring has separate
household red and black power wires.
□
Spread the wires apart so that the green and white wires
are on one side of the outlet box and the black wire is on the
other side.
□
Connect the green fan wires to the household ground wire
(this may be a green or bare wire) using a wire connecting nut
(CC).
□
Connect the receiver (H) black wire to the household black
(hot) wire using a wire connecting nut (CC).
□
Connect the receiver (H) red wire to the household red wire
using a wire connecting nut (CC).
□
Connect the receiver (H) white wire to the household white
(neutral) wire using a wire connecting nut (CC).
□
Secure each wire connecting nut using electrical tape.
□
Connect the receiver (H) to the fan by connecting the molded,
adaptor plug from receiver (H) with molded adaptor from the
fan motor assembly (E) together.
CC
Black
Red
Receiver
Antenna
9
Please contact 1-855-HD-HAMPTONBAY for further assistance.
Outlet Box
Green (or Bare)
Black
White
Green
Green
H
HAMPTONBAY.COM