Assigning The Image To The No-Signal Message And/Or A/V Mute Button - Epson PowerLite 500c User Manual Supplement

note
You can also set up your
image as a startup screen.
Use the Advanced menu to
enable the startup screen.
Saving the logo may take a few moments. Do not use the
projector or other sources (computer, video, speaker, etc.)
while the logo is being saved.
9. When you see the message "Saving the user logo is
completed," press the
the main menu.
Assigning the Image to the No-Signal
Message and/or A/V Mute Button
After your image is saved, you can set it up as the no-signal
message and/or the screen that's displayed when you press the
button.
A/V Mute
1. Press the button. You see the main menu listing,
Menu
with the Video menu highlighted.
2. Press the bottom edge of the
to highlight the
Setting
3. Press the button to select the Setting menu.
Enter
4. Press the bottom edge of the
to highlight
No-Signal Msg
5. Press the right side of the
sets your image as the screen displayed when the projector
is not receiving a signal.
6. If you want to set up your image as the A/V mute display,
press the bottom edge of the
to highlight
A/V Mute
7. Press the right side of the
sets your image as the screen displayed when you press the
button.
AV/Mute
8. When you're finished, press
To test your setting, press the
image. Press it again to turn off the image.
or button to redisplay
Menu Enter
button (or tilt it down)
Enter
menu.
button (or tilt it down)
Enter
.
button to select
Enter
button (or tilt it down)
Enter
.
button to select
Enter
or .
Esc Menu
button to display your
A/V Mute
Fine-Tuning Your Projector
. This
Logo
. This
Logo
57