Connecting Rf Jumper To Feeder; Figure 5-3 Inlet/Outlet Of Rf Cables; Figure 5-4 Inlet/Outlet Panel After Turnover - Huawei Airbridge BTS3606 Installation Manual

Installation Manual – BTS3606A Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
RF jumper to feeder
RF cables between CDDU/CHPA/CTRM (single-channel)
RF cables between CDDU/CMPA/CMTR (multi-channel)

5.3.1 Connecting RF Jumper to Feeder

If the BTS3606A operates in diversity receiving mode using two antennas, the
connecting procedure is as follows:
1) Remove all screws on the inlet/outlet and keep them properly, as shown in Figure
5-3.
(1) Screws on the inlet/outlet

Figure 5-3 Inlet/outlet of RF cables

2) Turn over the inlet/outlet panel, as shown in Figure 5-4.
(1) Internal screws on the inlet/outlet

Figure 5-4 Inlet/outlet panel after turnover

3) Remove the four screws inside, as shown in Figure 5-4.
4) Lead the Din connector of the RF jumper to the inlet according to the inlet ID and
connect it to the feeder under the base.
Huawei Technologies Proprietary
5-8
Chapter 5 Installing Cables