Seat Alhambra 2015 Owner's Manual page 81

Leaving home: necessary operations
– Automatically, at the end of the delay
period.
To switch sys- – When the vehicle is locked.
tem off: – When the light switch is turned to po-
sition .
– When the ignition is switched on.
Lighting around the exterior mirrors
The lighting around the exterior mirrors illu-
minates the door area on entering and leav-
ing the vehicles. It comes on when the vehi-
cle is unlocked, when the vehicle door is
opened and when the "Coming home" or
"Leaving home" function is switched on. If
the equipment includes the light sensor, the
lighting around the exterior mirrors only
comes when it is dark.
Note
The time taken for the headlights to go off
●
can be changed in the Lights & Visibility
and the function can be switched on or off
›››
page 47.
● When the "Coming home" function is on, if
the vehicle door is opened there is no audible
warning signal to advise that the light is still
on.
Lights and visibility
Adhesive strips for headlights or
adjusting headlights
In those countries where vehicles drive on
the other side of the road to the home coun-
try, the asymmetric dipped beam may dazzle
drivers of oncoming vehicles. Therefore,
when driving abroad, adhesive strips should
be attached to the headlights or the head-
lights should be adjusted accordingly.
The direction of the headlights can be adjus-
ted from the instrument panel, in the Tourist
light submenu of the Configuration menu
›››
page 51.
For those vehicles in which it is not possible
to adjust the headlights from the menu, ad-
hesive strips are used to cover certain parts
of the headlamp cover or the headlights may
be adjusted at a specialised workshop. For
further information, please refer to a special-
ised workshop. SEAT recommends visiting a
technical service.
menu
Note
Use of the Tourist light
sives on the headlights is only allowed if they
are to be used for a short period of time. To
modify the direction of the headlights perma-
nently, please take the vehicle to a special-
ised workshop. SEAT recommends visiting a
technical service centre.
Headlight range control, instrument
and switch lighting
Fig. 62
ment and switch lighting control
headlight range control
Instrument and switch lighting
1
When the headlights are switched on, the
brightness of the instruments and switch
lighting can be regulated by turning the
switch
Headlight range control
2
The headlight range control
option and the adhe-
modified according to the value of the head-
light beam and the vehicle load status. This
offers the driver optimum visibility and the
headlights do not dazzle oncoming drivers
›››
The headlights can only be adjusted when
the dipped beam is switched on.
Next to the steering wheel: instru-
and
1
2
›››
Fig. 62
.
1
›››
Fig. 62
.
is
2
»
79