Seat Alhambra 2015 Owner's Manual page 74

anti-trap function, deactivated for a short
time.
● After more than 10 seconds, the anti-trap
function is reactivated. The window will stop
once again if there is another difficulty or ob-
stacle.
● If the window will still not close, visit a spe-
cialised workshop.
WARNING
Closing the electric windows without the an-
ti-trap function can cause serious injury.
● Always close the electric windows careful-
ly.
Nobody should be in the way of the electric
●
windows, especially when the anti-trap func-
tion is deactivated.
The anti-trap function does not prevent fin-
●
gers or other parts of the body getting
pinched against the window frame and caus-
ing injury.
Note
The anti-trap function also operates if the
windows are closed from the outside of the
vehicle using the ignition key for convenience
›››
closing page 71.
72
Operation
Panoramic sliding sunroof*
Introduction
WARNING
Careless or uncontrolled use of the panoram-
ic sliding sunroof can cause serious injuries.
● Only close the panoramic sliding sunroof
and the sun blind when nobody is in the way.
Always take all the keys with you whenever
●
you leave the vehicle.
● Never leave children or disabled persons in
the vehicle, particularly if they have access to
the keys. Uncontrolled use of the key could
lock the vehicle, start the engine, turn on the
ignition and operate the panoramic sliding
sunroof.
The panoramic sliding sunroof can be oper-
●
ated for up to about ten minutes after the ig-
nition has been switched off, provided the
driver door and the front passenger door are
not opened.
Note
In case of a fault in the operation of the pan-
oramic sliding sunroof, the anti-trap function
will not operate correctly. Visit a specialised
workshop.
Opening or closing the panoramic
sliding sunroof
On the interior roof lining: use the ro-
Fig. 57
tary button for opening and closing
On the interior roof lining: Press the
Fig. 58
button and pull on it to lift and close the slid-
ing sunroof.
To open the panoramic sliding sunroof, the
switch must be in the position .
1