Seat Alhambra 2015 Owner's Manual page 255

Protect hands and skin from hot parts.
●
Do not place the air compressor or inflator
●
tube onto flammable materials while they are
hot.
Before storing the equipment, let it cool.
●
● If a minimum pressure of 2.0 bar
(29 psi / 200 kPa) cannot be reached, the tyre
is badly damaged. In this instance, the seal-
ant will not be able to seal the tyre. Do not
continue driving. Seek specialist assistance.
CAUTION
The air compressor should be turned off after
a maximum of 8 minutes since otherwise it
will overheat. Before switching it on again, let
it cool for a few minutes.
Check after 10 minutes of driving
›››
Fig. 190
Screw the inflator tube
and check the tyre pressure on the gauge
Equal to or below 1.3 bar (19 psi/130 kPa):
● Stop driving! The tyre could not be suffi-
ciently sealed with the tyre mobility system.
● You should obtain professional assistance
›››
.
Equal to or above 1.4 bar (20 psi/140 kPa):
Correct the tyre pressure until the correct
●
›››
level is reached page 231.
Emergencies
● Carefully head to the nearest specialised
workshop at a maximum speed of 80 km/h
(50 mph).
● Ask the workshop to change the damaged
tyre.
WARNING
Driving with a tyre that cannot be sealed is
dangerous and may lead to accidents and se-
rious injury.
Do not continue driving if the tyre pressure
●
is 1.3 bar (19 psi / 130 kPa) or lower.
● Seek specialist assistance.
Starting assistance
Introduction
If the engine fails to start because of a dis-
again
8
charged battery, the battery of another vehi-
.
7
cle can be used to start the engine. Before
starting, check the magic eye on the battery
›››
page 227.
For starting assistance, jump lead cables con-
forming to the standard DIN 72553 are re-
quired (see the cable manufacturer instruc-
tions). The jump lead cable must be at least
2
25 mm in section (0.038 inches
engines, and 35 mm
sel engines.
For vehicles whose battery is not in the en-
gine compartment, the jump leads should
only be connected to the starting assistance
connection points in the engine compart-
ment.
Incorrect use of jump leads and incorrectly
jump starting could cause the battery to ex-
plode resulting in serious injury. Please ob-
serve the following rules to minimise the risk
of a battery explosion:
●
the same voltage (12V) and approximately
the same capacity (see markings on battery)
as the flat battery.
●
battery. A flat battery can also freeze at tem-
peratures close to 0 °C (+32 °F).
●
then it must be replaced.
●
leased when the battery is being charged. Al-
ways keep lit cigarettes, flames, sparks and
fire far from the battery. Never use a mobile
telephone when connecting and removing the
jump leads.
●
areas given that when the battery is charged
by outside assistance, it creates a mix of
2
) for petrol highly explosive gases.
2 (0.054 inches 2 ) for die-
●
with moving parts in the engine compart-
ment.
WARNING
The battery providing current must have
Never charge a frozen or recently thawed
If a battery is frozen and/or has been frozen
A highly explosive mixture of gases is re-
Charge the battery only in well ventilated
Jump leads should never enter into contact
»
253