Seat Alhambra 2015 Owner's Manual page 254

Tyre valve remover
1
Sticker indicating maximum speed "max.
2
80 km/h" or "max. 50 mph"
Filler tube with cap
3
Air compressor
4
ON/OFF switch
5
1)
Air bleed screw
6
Tyre pressure monitoring
7
Tube for inflating tyres
8
12 volt connector
9
Bottle of sealant
10
Spare insert for valve
11
The valve insert remover
lower end for a valve insert. The valve insert
can only be screwed or unscrewed in this
way. This also applies to its replacement part
.
11
Seal and inflate a tyre
Sealing a tyre
Unscrew the tyre valve cap.
●
● Use the enclosed extractor
to unscrew the valve insert. Place it on a
clean surface.
1) An inflator tube may also be included.
252
● Shake the bottle of sealant
well.
● Screw the inflator tube
the sealant bottle in a clockwise direction.
The seal on the mouth of the bottle pierces
automatically.
● Remove the lid from the filling tube
›››
Fig. 190
tube into the tyre valve.
1)
● Keep the bottle mouth facing down and
empty all the contents into the tyre.
● Remove the empty bottle from the valve.
Screw in the valve insert again with the aid
●
of the extractor
has a gap at the
1
Inflating the tyre
● Screw the tyre inflator tube
of the air compressor into the tyre valve.
● Check whether the air bleed screw
›››
Fig. 190
● Start the engine and leave it running in
neutral.
● Attach the connector
of the vehicle's 12 volt sockets
›››
● Switch on the air compressor with the
Fig. 190
1
ON/OFF switch
● Keep the air compressor running until it
reaches 2.0 to 2.5 bar (29-36 psi /
Advice
›››
Fig. 190
10
›››
Fig. 190 into
3
and insert the open end of the
3
›››
Fig. 190 .
1
›››
Fig. 190
8
is tightened.
6
›››
Fig. 190 to one
9
›››
page 119.
›››
Fig. 190 .
5
›››
200-250 kPa) . Do not leave it running
›››
for more than 8 minutes .
● Switch off the compressor.
If it fails to reach a pressure of between
●
2.0 and 2.5 bar (29-36 psi / 200-250 kPa),
unscrew the inflator tube from the tyre valve.
● Move the vehicle some 10 metres forwards
or backwards so that the sealant is evenly
distributed in the tyre interior.
● Securely screw the compressor tyre inflator
tube into the tyre valve again and repeat the
inflation process.
If the indicated pressure can still not be
●
reached, the tyre is too badly damaged. The
tyre cannot be sealed with the tyre mobility
system. Do not continue driving. You should
obtain professional assistance
● Disconnect the air compressor and unscrew
the inflator tube from the tyre valve.
● If a pressure between 2.0 and 2.5 bar
(29-36 psi / 200-250 kPa) is reached, then
continue driving at 80 km/h (50 mph) maxi-
mum.
After 10 minutes, check the pressure again
●
›››
page 253.
WARNING
When inflating the tyre, the air compressor
and the inflator tube may become hot.
›››
.