Seat Alhambra 2015 Owner's Manual page 45

Table of Contents

Advertisement

Press button
three times. The odometer
display flashes on the instrument panel dis-
play.
Press button
once. "mph"
0.0 / SET
or "km/h" is displayed briefly instead of the
odometer.
This activates the second speed display. To
switch it off, repeat the procedure.
This option cannot be deactivated in models
destined for countries in which the second
speed must always be visible.
Start-Stop operating display.
Updated information relating to the status is
displayed on the instrument panel
›››
page
156.
WARNING
›››
Observe the safety warnings
and warning lamps on page
47.
WARNING
Even though outside temperatures are above
freezing, some roads and bridges may be icy.
At outside temperatures above +4°C
(+39°F), even when the "ice crystal symbol"
is not visible, there may still be patches of ice
on the road.
Never rely on the outside temperature indi-
cator!
Note
Different versions of the instrument panel
are available and therefore the versions and
instructions on the display may vary. In the
case of displays without warning or informa-
tion texts, faults are indicated exclusively by
the warning lamps.
When several warnings are active at the
same time, the symbols are shown succes-
sively for a few seconds and will stay on until
the fault is rectified.
Compass*
in Control
Fig. 35
Magnetic zones
The compass does not require calibration in
vehicles for which the navigation system was
mounted at the factory. The option compass
disappears.
The compass in vehicles in which the naviga-
tion system was not mounted at the factory,
Cockpit
is permanently and automatically calibrated.
If electronic or metal accessories (mobile
phone, television) are subsequently mounted
in the vehicle, the compass should be recali-
brated manually.
Adjusting the magnetic zone
option Compass and Zone .
the position of the vehicle
( 1-15 ).
Calibrating compass
To calibrate the compass you must be in one
of the valid magnetic zones with sufficient
space to be able to trace a circumference
with the vehicle.
option Compass and Calibrate .
circumference to calibrate the compass
driving at approximately 10 km/h (6 mph).
When the corresponding cardinal point is dis-
played, the calibration is complete.
Switch the ignition on.
Select the Settings menu followed by the
Select the magnetic zone corresponding to
›››
Fig.
Adjust and confirm the magnetic zone
Switch the ignition on.
Select the Settings menu followed by the
Confirm the message Describe a complete
and then trace a complete circumference
OK
35.
with
43

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents