Seat Alhambra 2015 Owner's Manual page 249

Full hubcaps*
Removing the full hubcap
Fig. 183
Removing the full hubcap
● Take the wheel brace and the wire hook
›››
from the vehicle tool kit page
● Hook the wire through one of the grooves
on the hubcap.
● Insert the wheel brace onto the wire hook
›››
Fig. 183 and pull the hub cap in the direc-
tion shown by the arrow.
Fitting hubcaps
Before mounting the full trim, the anti-theft
wheel lock must be threaded into position
›››
Fig. 186
or . Otherwise it will not be
2 3
possible to mount the full hubcap.
Press the trim against the wheel so that the
space for the valve fits over the tyre valve
›››
Fig. 186 . Make sure that the hubcap is
1
correctly fitted all the way around the wheel.
Wheel bolt caps
Fig. 184 Removing the wheel bolt caps
● Take the wire hook from the vehicle tool kit
›››
page 244.
● Insert the wire hook in the cap through the
244.
›››
opening Fig. 184
direction of the arrow.
The caps protect the wheel bolts and should
be remounted after changing the tyre.
The anti-theft wheel locking bolt has a spe-
cial cap. This only fits on anti-theft locking
bolts and is not for use with standard wheel
bolts.
Emergencies
and pull outwards in the
Wheel bolts
Fig. 185 Changing a wheel: Slacken the
wheel bolts.
Changing a wheel: tyre valve
Fig. 186
position of anti-theft wheel locking bolt
.
3
Only use the tool supplied with the vehicle to
loosen the wheel bolts.
Loosen the wheel bolts only about one turn
before raising the vehicle with the jack.
and
1
or
2
»
247