Installation Of Electrical Devices - HAKO Citymaster 2200 Operating Manual

Safety instructions

1.5.16 Installation of electrical devices

General
Attention
The vehicle is equipped with electronic components and parts whose function can be influenced
•
by electromagnetic emissions of other devices. Such influence can lead to danger to persons and
safety-relevant functions if the following safety instructions are not complied with:
• If electrical and electronic devices and/or components, which also are connected to the vehicle
electrical system, are installed subsequently in the vehicle, the user must examine in his own
responsibility whether the installation causes interference to the vehicle electronics or to other
components, a renewed acceptance test may be necessary.
Above all it must be ensured that the subsequently installed electrical and electronic components
•
comply with the EMC Directive 2014/30/EC in the relevant valid edition and bear the CE marking.
In addition, the following requirements especially must be fulfilled for the subsequent installation of
•
mobile communication systems (e.g. radio, telephone):
• Only devices with approval according to the valid national regulations (e.g. BZT approval in the
Federal Republic of Germany) may be installed.
• The device must be installed permanently.
• Operation of portable or mobile devices inside the vehicle is permitted only through a connection
to a permanently installed outside antenna.
• The transmitter must be installed in a separate location from the vehicle electronics.
• When installing the antenna, pay attention to correct installation with good ground connection
between antenna and vehicle ground.
26
01-1481-00-00.fm