Advertisement
◦ Damaged protective devices and parts must be properly repaired or replaced by a recog-
nised workshop, insofar as nothing different is specified in the operating manual.
◦ Damaged switches must be replaced at a customer service workshop.
◦ Do not use any faulty or damaged connection cables.
◦ Do not use any electric tool on which the switch cannot be switched on and off.
•
Attention!
Special caution for double mitre cuts.
•
Attention!
Use of other insertion tools and other accessories can entail a risk of injury.
•
Have your electric tool repaired by a qualified electrician. This electric tool conforms to the
applicable safety regulations. Repairs may only be performed by an electrician using original
spare parts. Otherwise, accidents can occur.
•
Do not use the cable for purposes for which it is not intended. Do not use the cable to pull
the plug out of the outlet. Protect the cable from heat, oil and sharp edges.
Additional safety instructions
Safety precautions concerning saw blades
Warning!
•
Do not use damaged, cracked or deformed saw blades.
•
Replace a worn table insert.
•
Only use saw blades recommended by the manufacturer which conform to EN 847-1.
Warning!
•
Keep attention when changing the saw blade. The cutting width is not smaller and the main
blade thickness of the saw blade is not greater than the thickness of the gap wedge!
•
Make sure that a suitable saw blade for the material to be cut is selected.
•
Wear suitable personal protective device. This includes a hearing protection to avoid the risk of
becoming hearing impaired, a respiratory protection to avoid the risk of inhaling harmful dust.
•
Wear gloves when handling saw blades and rough materials.
•
Carry saw blades in a container whenever practical.
•
Wear goggles. Sparks generated during work or splinters, chippings and dust coming from the
device can lead to loss of eyesight.
•
Connect a dust collecting device to the electric tool when sawing wood. The emission of dust is
influenced, among other things, by the type of material to be processed, the significance of local
separation (collection or source), and the correct setting of the hood/guide plates/guides.
•
Do not use saw blades made of high-speed alloy steel (HSS steel).
•
In times of non-use, keep the push stick or the push block with the electrical power tool in its
holder at all times.
Safety precautions concerning maintenance and repair
•
Pull out the mains plug for any adjustment or repair tasks.
•
The generation of noise is influenced by various factors, including the characteristics of saw
blades, condition of saw blade and electric tool. Use saw blades which were designed for re-
duced noise development, insofar as possible. Maintain the electric tool and tool attachments
regularly and if necessary, initiate repairs in order to reduce noise.
•
Report faults on the electric tool, protective devices or the tool attachment to the person respon-
sible for safety as soon as they are discovered.
Safe work
•
Use the push stick or handle with sliding wood, to pass the workpiece securely out off the saw
blade.
•
Make sure that the riving knife is always used, and is set up correctly.
•
Use the upper blade guard and set it to the correct position.
•
Only use saw blades for which the maximum permissible speed is not lower than the maximum
spindle speed of table saws and which are suitable for the material to be cut.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61950
Page 5
05
2021-1
Advertisement
