Advertisement
◦ Do not use the electric tool to cut firewood.
•
Wear suitable clothing.
◦ Do not wear wide clothing or jewellery, which can become entangled in moving parts.
◦ When working outdoors, anti-slip footwear is recommended.
◦ Tie long hair back in a hair net.
•
Use protective device.
◦ Wear protective goggles.
◦ Wear a mask when carrying out dust-creating work.
•
Connect a dust extraction device if you will process wood, materials similar to wood, or
plastics.
◦ If connections for dust extraction and a collecting device are present, make sure that they
are connected and used properly.
◦ When processing wood, materials similar to wood, and plastics, operation in enclosed
spaces is only permitted with the use of a suitable extraction system.
•
Secure the workpiece.
◦ Use clamps or a vice to hold the workpiece in place. In this manner, it is held more securely
than with your hand.
◦ An additional support is necessary for long work-pieces (table, trestle, etc.) in order to pre-
vent the machine from tipping over.
◦ Always press the workpiece firmly against the working plate and stop in order to prevent
bouncing and twisting of the workpiece.
•
Avoid abnormal posture.
◦ Make sure that you have secure footing and always maintain your balance.
◦ Avoid awkward hand positions in which a sudden slip could cause one or both hands to
come into contact with the saw blade.
•
Take care of your tools.
◦ Keep cutting tools sharp and clean in order to be able to work better and more safely.
◦ Follow the instructions for lubrication and for tool replacement.
◦ Check the connection cable of the electric tool regularly and have it replaced by a recog-
nised specialist when damaged.
◦ Check the extension cables regularly and replace them when they are damaged.
◦ Keep the handle dry, clean and free of oil and grease.
•
Pull the plug out of the socket.
◦ During non-use of the electric tool or prior to maintenance and when replacing tools such
as saw blades, bits, milling heads.
◦ When the saw blade is blocked due to abnormal feed force during cutting, turn the machine
off and disconnect it from power supply. Remove the work piece and ensure that the saw
blade runs free. Turn the machine on and start a new cutting operation with a reduced feed
force.
◦ Never remove loose splinters, chips or jammed wood pieces from the running saw blade.
•
Do not leave a tool key inserted. Before switching on the machine, make sure that keys and
adjusting tools are removed.
•
Avoid inadvertent starting. Make sure that the switch is off when you plug the plug into an
outlet.
•
Use extension cables for outdoors.
◦ Only use approved and appropriately identified extension cables for use outdoors.
◦ Only unroll the cable from its reel.
•
Stay attentive. Pay attention to what you are doing. Stay attentive when working. Do not use
the electric tool when you are distracted.
•
Check the electric tool for potential damage.
◦ Protective devices and other parts must be carefully inspected to ensure that they are fault-
free and function as intended prior to their being re-used.
◦ Check whether the moving parts function faultlessly and do not jam, or whether parts are
damaged. All parts must be correctly mounted and all conditions must be fulfilled to ensure
fault-free operation of the electric tool.
◦ The moving protective hood may not be fixed in the open position.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61950
Page 4
05
2021-1
Advertisement
