Advertisement
•
Set the parallel stop in accordance with the workpiece height and the desired width.
•
Switch on the saw.
•
Place your hands (with fingers closed) flat on the workpiece and push the workpiece along the
parallel stop and into the blade.
•
Guide at the side with your left or right hand (depending on the position of the parallel stop) only
as far as the front edge of the guard hood.
•
Always push the workpiece through to the end of the splitter.
•
The piece cut off remains on the saw table until the blade is back in its position of rest.
•
Secure long workpieces against falling off at the end of the cut (e. g., with a roller stand).
Cutting narrow workpieces
•
Be sure to use a push stick (9) when making longitudinal cuts in workpieces smaller than
120 mm in width. A push stick is supplied with the saw! Replace a worn or damaged push stick
immediately.
•
Be sure to use a push block when making longitudinal cuts in very narrow workpieces with a
width of 30 mm and less. The low guide face of the parallel stop is best used in this case.
•
There is no push block supplied with the saw! (Available from your specialist dealer.) Replace
the push block without delay when it is worn.
Bevel cuts
•
Bevel cuts must always be used using the parallel stop (15).
•
Set the blade to the desired angle.
•
Set the parallel stop in accordance with the workpiece width and height.
•
Carry out the cut in accordance with the work-piece width.
Cross cuts
•
Slide the cross stop (7) into one of the grooves in the table and adjust to the required angle. If
you also want to tilt the blade, use the groove which prevents your hand and the cross stop from
making contact with the blade guard.
•
Press the workpiece firmly against the cross stop.
•
Switch on the saw.
•
Push the cross stop and the workpiece toward the blade in order to make the cut.
Warning!
•
Always hold the guided part of the workpiece. Never hold the part which is to be cut off.
•
Push the cross stop forward until the workpiece is cut all the way through.
•
Switch off the saw again. Do not remove the pieces cut off until the blade has stopped rotating.
Replacing the power cord
Danger!
If the power cable for this device is damaged, it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel to avoid danger.
Cleaning, maintenance and ordering of spare parts
Cleaning
•
Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible.
Wipe the device with a clean cloth or blow it with compressed air at low pressure.
•
We recommend that you clean the device immediately each time you have finished using it.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Danger!
Always pull out the mains power plug
before starting any cleaning work.
Item 61950
Page 15
05
2021-1
Advertisement
