Advertisement
Please note that our device has not been designed for use in commercial, trade or industrial applications.
Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for
equivalent purposes.
The device is to be operated only with suitable saw blades (saw blades made of HM or CV) It is prohib-
ited to use any type of HSS saw blade and cutting-off wheel.
To use the device properly, you must also observe the safety information, the assembly instructions and
the operating instructions to be found in this manual. All persons who use and service the device have
to be acquainted with these operating instructions and must be informed about the potential hazards of
the device. It is also imperative to observe the accident prevention regulations in force in your area. The
same applies for the general rules of health and safety at work.
The manufacturer will not be liable for any changes made to the device nor for any damage resulting
from such changes. Even when the device is used as prescribed it is still impossible to eliminate certain
residual risk factors.
The following hazards may arise in connection with the construction and design of the device:
•
contact with the saw blade in the uncovered saw zone;
•
reaching into the running saw blade (cut injuries);
•
kick-back of workpieces and parts of workpieces;
•
saw blade fracturing;
•
catapulting of faulty carbide tips from the saw blade;
•
damage to hearing if essential ear-muffs are not used;
•
harmful emissions of wood dust when used in closed rooms.
Technical data
Intake voltage
Power (W)
Max. speed (rpm)
Saw blades (×2) (㎜)
Size (㎜)
With extension left/right (㎜) 642×940
Table
Height (㎜)
Max. cutting depth 90° (㎜)
Max. cutting depth 45° (㎜)
Height adjustment (㎜)
Saw blade tilt (°)
Weight (㎏)
Operating mode S6 25 %: Continuous operation with idling (cycle time 10 min). To ensure that the motor
does not become excessively hot, it may only be operated for 25 % of the cycle at the specified rating
and must then be allowed to idle for 75 % of the cycle.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
220–240 V~50 Hz
S1
1800
S6 25 %
2000
5500
For wood
For fine cuttings
642×485
830
85
65
0–85
0–45
19
Item 61950
250×30×2.8 (24 teeth)
250×30×2.8 (48 teeth)
Page 10
05
2021-1
Advertisement
