Table of Contents
Advertisement
2. System is Muted when the Red Mic LED is alternately blinking on and off
quickly.
3. Press and hold the minus
button to turn OFF the Device Mute feature.
PTT Button
The large square button on the front of the Firecom Connect allows for
communication over two-way radios via PTT (and intercom operation in Intercom PTT
and Intercom Toggle modes).
Simply press and hold the PTT
over the two-way radio frequency connected to your ComHub.
Wireless Bluetooth® Pairing
1. Turn ON your Bluetooth device.
2. Turn ON the
Firecom
Connect.
3. Make sure your Bluetooth device is in
pairing mode (follow your
manufacturer's instructions).
Firecom
4. Put the
Connect into pairing
mode by simultaneously pressing PTT
and plus
buttons, then hold for 2
seconds and release. The Bluetooth LED
will be blinking blue.
5. Pairing successful when Bluetooth LED is
solid Blue.
Notes:
•
Bluetooth pairing will timeout after 40 seconds.
•
When a corded headset is plugged in, Bluetooth turns off.
•
Bluetooth headsets (or other Bluetooth devices) will connect to other Bluetooth
devices they have previously paired to. Ensure your Bluetooth device you are
using with the Firecom Connect "Forgets" these other devices. The easiest way
to achieve this is to reset the headset.
•
Firecom Connect only remembers the last device it was paired to.
•
The pairing command clears the previous pairing
•
SCH305-BT ComHubs can Bluetooth pair to Firecom Connects in Bluetooth
pairing mode. Make sure your SCH305-BT ComHub is powered OFF while you are
Bluetooth pairing your Bluetooth headset to the Firecom Connect.
button again or press and release the PTT
–
button on the Firecom Connect to communicate
Wireless DECT7
DECT7 Firecom Connect devices have the ability to use the Firecom DECT, DECT6,
DECT7 and IP-DECT7 wireless Base Stations for communication. Protected regional
frequencies in each region ensure interference free operation.
DECT7 Pairing
DECT7 Wireless Firecom Connect devices use a semi-permanent link to a DECT7 Base
Station. No additional steps are required once a Firecom Connect has been paired.
Each time thereafter, the Firecom Connect will remember the Wireless Base Station
and automatically reconnect.
To Create a New DECT Pairing
1. Place Base Station into pairing
mode (see base station manual for
details.)
2. With
the
Firecom
powered on, simultaneously push
and hold the Power
buttons for 2 seconds, then
release. The DECT LED light will
blink green while pairing.
3. The LED will be solid green when
connection is successful. If it does
not, repeat the pairing process.
Note: DECT paring will timeout after 40 seconds.
Out of Range Warning:
• If Firecom Connect has low radio signal (RSSI) to its Base Station it will report
Radio Level Low".
• If Firecom Connect loses signal to the base station it will report
Disconnected".
•
If Firecom Connect regains signal to the base station it will report
Connected".
• If device is not connected to a base station it will power down after 10 minutes.
6 |
P a g e
Connect
and PTT
"DECT
"Base station
"Base station
Advertisement
Table of Contents
