Table of Contents
Advertisement
Station selecting can be made with having to repeatedly accessing the Advanced
Menu).
Button Press
Advanced Menu
Plus
Minus
Quick Launch –
Quick plus
Channel Mode
Quick Launch –
Long plus
Multi Base Mode
Channel Mode
The Firecom Connect can be used in Channel Mode by enabling Channel Mode on
the Base Station. Up to 5 channels are available through the Wireless Base Station
when used in this configuration. Follow the steps below to configure your Base
Station.
Note: The Base Station needs to be put into Channel Mode for the Firecom Connect
to recognize the Quick Launch command.
Setting the number of channels on your Base Station
To enter configuration mode:
1. Unplug the Base Station (or cycle power on your ComHub, then plug it back in
while holding the position 3 pairing button on the Base Station.
2. Hold the pairing button until the green channel indicator LED turns on.
3. The Base Station is now in ComHub mode.
Voice Prompt
Power
"Advanced Menu"
–
& minus
"Channel"
–
& minus
–
"Multi-base[X]"
4. To set the number of available channels, press the pair button corresponding to
the number of channels desired (button 2 = 2 channels, etc). The current number
of channels is shown with a green LED on the associated Mode/Channel Indicator
(e.g. Port 5 = 5 channels).
5. To exit configuration mode, unplug your Base Station (or cycle power on your
ComHub) from power, then plug it back in. The Base Station is now ready to use.
Setting up the Firecom Connect for Channel Mode:
Now that your Base Station is set up in Channel Mode, your Firecom Connect Quick
Launch-Channel Mode function is enabled. To change between your desired Channel:
1. Quick press the plus
hear the
"Channel"
voice prompt.
a. If you do not hear the
2. Use the plus
or minus
3. Once you hear the desired channel voice prompt, repeat Step 1. You will hear the
"Channel Exiting"
voice prompt. (Pressing Power
Notes:
•
To switch between the different Channels, repeat the Quick Launch-Channel
Mode steps
•
If you do not Exit the Quick Launch-Channel Mode, you will not be able to adjust
your Firecom Connect volume. Simply perform the Quick Launch button press
and you will Exit the Quick Launch.
9 |
P a g e
and minus
buttons simultaneously and release. You will
–
"Channel"
voice prompt, simply retry the step 1.
buttons to select your desired channel.
–
also exits Channel Selection.)
Advertisement
Table of Contents
