Speaker The speaker broadcasts audio when headsets are not used. Radio transmit and receive can be added to the pantherC series with an analog Status Light interface unit. The optional interface unit provides full radio communications with The status light illuminates when a station is operating properly.
INTERCOM MODELS INSTALLATION Optional Top Mounting There are two pantherC series intercom models: base stations and remote stations. Base Station Remote Station Base stations broadcast Remote stations have sound via a speaker “live” voice activated when audio is provided microphones that will from another unit.
WIRE CONNECTIONS SYSTEM WIRING Over 100 devices can operate on one network, but only 8 full-duplex conversations Power can occur simultaneously. 12 VDC (2.5 amps maximum) A 5 amp fuse is required The 2-wire network is connected by wiring intercoms in series. The positive network wire of one unit is connected to the positive network wire of the second unit.
Incoming radio traffic will be heard on base station speakers and headsets at remote and base stations, but not heard on remote station speakers. A Firecom 10 series headset with red PTT button is required to transmit over the radio.
• Check if other users can hear you talk on the intercom. If you can talk on the If a problem persists in a headset or intercom unit, contact Firecom for a Return intercom but can not hear through the speaker, the intercom is malfunctioning Merchandise Authorization (RMA) number.
Connections on network cable should be kept in pairs. Do not route wires individually to the pantherC series 2-wire network. With the integration of this unit, anyone on or connect independently. Always treat both wires as a pair. What happens to one the 2-wire network will be able to send and receive radio communications, as well wire should happen to the other wire at the same location.
Page 9
The units in a network are connected in series. When retrofitting a pantherC series system into a previously installed wiring system, it is important to trace the wiring and confirm that no additional wires have been spliced into the intended network wires.
Safety Information problem in that section. Firecom’s pantherC series intercom speaker is loud enough to cause hearing damage. Use the volume control provided on the intercom to reduce the speaker volume to a safe level for the environment in which the intercom is being used or use Firecom headsets to reduce noise.