Table of Contents
Advertisement
WARNING: The vehicle is
not armed or locked down.
The Parking lights will flash
twice to indicate Ready
mode is set. To see the
icon,
refresh
remote screen by pressing
Remote-starting
1.
Press the
The remote will beep once and the LCD will display "START".
2.
3.
The remote will confirm the remote starter's activation by beeping 3 times.
If your vehicle does not start on the first attempt, the system will shut down, wait a few seconds
and try to start the engine again. There will be 3 start attempts before the system gives up.
Driving Off
With the vehicle running remotely, press the
unlock the doors. Enter the vehicle and do the following:
Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the CRANK
1.
position while the engine is running. This would cause the starter motor to re-engage.)
2.
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Note: On some Push-To-Start (PTS) vehicles, no takeover is possible as pressing the brakes will
shut the engine down. Please talk to your technician to determine if the "Takeover mode" can be
set for your vehicle.
Arming and disarming the starter kill (if installed)
This added security feature will prevent the vehicle from starting with the Ignition key when the
starter kill is armed. If the system was installed with the starter kill option, the vehicle will not be
able to start with the key unless the system has been unlocked first or put into Valet Mode
(page 12).
Note: If the Starter Kill is installed, the vehicle will benefit from a protection against starter motor
damage that could occur after remote-starting the engine should the user, by force of habit, turn
the ignition key to the CRANK position.
The Starter Kill (if installed) can be configured by the installer either to Passive Mode (so as to arm
automatically) or Active Mode (so as to require the user's intervention for arming). By default, the
Remote Car Starter is configured to Passive Mode.
P.10
b.
to unlock the doors and
shut down the engine;
c.
to shut down the engine
without affecting the doors.
WARNING: Engine runs until the
pre-programmed
expires.
The
icon will appear on your
the
screen.
button for approximately 1 second and release.
interaction.
WARNING: Do not leave
run
time
your keys in the vehicle!
The Parking lights will flash
twice to indicate Ready mode
is set. To see the
refresh the remote screen by
pressing
button to disarm the starter kill (if installed) and
icon,
.
User Guide
Advertisement
Table of Contents
