Download Print this page

Epson Stylus Color 3000 User Manual: Preparing For Standalone Installation

Epson stylus color 3000: user guide.
Hide thumbs

Advertisement

Preparing for Standalone Installation

If you connected the printer to a standalone Macintosh, you
need to make AppleTalk active. Open the Chooser in the Apple
menu and make sure AppleTalk is active.
You must set your Network Control Panel to Remote only if
you've connected your printer in one of these configurations:
You're using System 7.51 or lower and have connected the
printer to the printer port on your Macintosh
You're using System 7.52 or higher and have connected the
printer to the modem or printer port on your Macintosh
and do not have an optional interface card installed
For other configurations, go to "Installing on a Standalone or
Print Server System" on the next page.
Follow these steps to set up the printer as Remote only:
1. Restart your Macintosh with all extensions turned off
except your CD-ROM drive. Then turn on your printer.
2. Insert the StylusRIP CD-ROM in the CD-ROM drive.
3. Locate the Extensions folder within the System folder on
your hard disk drive.
4. Drag the
Remote Only
System Extensions folder.
5. From the Apple menu, open the Control Panels utility.
Click the
Network
system uses the Open Transport protocol, there is no
icon; in this case, open the AppleTalk folder and
Network
select
Remote Only
Installing the StylusRIP Software
file from the CD-ROM to the
icon and select
Remote Only
in the
Connect via
1-3
. (If your
list box.)

Advertisement

   Also See for Epson Stylus Color 3000

   Related Manuals for Epson Stylus Color 3000

This manual also for:

Stylus rip

Comments to this Manuals

Symbols: 0
Latest comments: