Printing with the StylusRIP Software
3. Open the StylusRIP folder on the hard disk and
run the server software, you see a dialog box asking you to
select your port or your printer name.
4. Select the printer or modem port if you connected the
printer by serial cable.
If you connected the printer by a network interface card
and use AppleTalk zones, select the printer's zone and then
select the printer name. Or use the
locate the printer on your network.
If you change your printer connection later, you must
reconfigure StylusRIP for your new port. First, quit StylusRIP,
turn off your printer, and disconnect it from the previously
selected port or interface. Then connect the printer to the new
port or interface. Open the StylusRIP folder on your hard disk
and drag the CPSPref file into the trash. Then perform steps 1
through 3 in this section. When you see the Connection dialog
box, select your printer on the new port or interface.
updated printer and then prepares it for printing.
6. If you're using StylusRIP on a standalone Macintosh, quit
the StylusRIP Server; you're ready to start printing.
If you're using StylusRIP on a network, open the File menu
. The StylusRIP Server software searches for the
icon. The first time you