Marker Menu - OSEE LCM215-E Series User Manual

Menu Operations
LINE2
Select input source format for LINE2 among LINE2(CVBS), LINE2(Y/C) and
LINE2(YPBPR).
For LINE2(CVBS) interface, LINE2(Y/C) interface and LINE2(YPbPr) interface share
the same group of physical interfaces, select the signal source format for LINE2
according to the cable connection mode.
To select a signal source format for LINE2, you can set the menu item INPUT
SELECTLINE2 to be LINE2(CVBS), LINE2(Y/C) or LINE2(YPBPR), in addition,
press INPUT button to pop up the SOURCE MENU for LINE2 selection.
Figure 4.1-8 LINE2 SWITCHING in SOURCE MENU

NTSC PHASE item is available only when NTSC format signal is input, while,
only the LINE1 and LINE2 (CVBS) interface support NTSC format signal.

4.1.3 MARKER Menu

The MARKER menu items are used to display various markers and set the marker
preference. It provides Area Marker, Center Marker, Safety Marker and Cross
Hatch, while, you can set the aspect ratio of safety area, the darkness outside of the
safety area, etc. These markers can be flexibly controlled by the following settings, as
shown in Figure 4.1-9:
SOURCE
SDI1
SDI2
LINE1(CVBS)
LINE2(CVBS)
LINE2(Y/C)
LINE2(YPBPR)
HDMI
28