OSEE LCM215-E Series User Manual page 44

Menu Operations

Normal: the signal format is displayed as 1080i59.94, NTSC, or 1280X1024,
etc. when the input is supported by the monitor.
Particularly, When the monitor is set in PIP or PBP mode by setting the
CONFIGSUB IN TYPE menu item, the Status Information for the main picture
displays at the top left corner of the screen, and the Status Information for the slave
picture displays at the top right corner of the screen.
Set DISPLAYSTATUS DISPLAY item to be OFF to completely turn the Status
Information off, and it will effect on the AFD information display.
AFD (Active Format Description) INFORMATION
If activate the AFD information, the embedded aspect ratio signal and AFD code in
the video signal will be extracted and displayed as an AFD marker at the top center of
the screen.
Make sure you have set the DISPLAYSTATUS DISPLAY item to be ON or Auto,
before you switch DISPLAYAFD DISPLAY item to be ON.

Please refer to the international standard SMPTE2016-1-2007 for the details
about AFD display.
WAVE FORM & VECTOR
Set DISPLAYWFM FORM TYPE item to be MODE1(WAVE FORM& VECT75),
MODE2(WAVE FORM&VECT100), VECT100, VECT75, or WAVE FORM, the
waveform window or the vector window will be displayed at the desired position on
the image.
Figure 4.1-17 WAVEFORM and VECTOR
38