Installing Epson Status Monitor 2 - Epson FX-2180 User Manual

Installing EPSON Status Monitor 2

To install the Status Monitor, follow these steps:
1. Make sure that you have installed the printer driver for
Windows 95. If not, install the printer driver for Windows 95
as described in Chapter 1.
Note:
If you installed the Status Monitor before the driver, install the
printer driver, then install the Status Monitor again.
2. Insert Disk 1 of the EPSON Status Monitor 2 software in a disk
drive.
Click Start and then click Run .
3.
Type A:\Setup . (If you inserted the disk in a drive other than
4.
drive A, substitute the appropriate letter.) Then click OK .
Follow the on-screen instructions, then click Finish to complete
5.
the installation procedure.
After you install EPSON Status Monitor 2 and restart your
computer, the Status Monitor starts automatically and adds a
printer-shaped background monitoring icon to the taskbar at
the bottom of your computer screen. This icon only appears
when the Status Monitor is active.
Using EPSON Status Monitor 2
6
6-3