Epson FX-2180 User Manual page 79

5. Attach the paper to the pull tractor's sprockets as described in
"Loading paper onto the pull tractor" on page 2-24.
6. Set the paper release lever to the pull tractor position. Then
remove any slack in the paper between the push and pull
tractors using the micro adjust feature (described on page
2-37) if necessary.
7. Move the paper release lever back to the push tractor position
you set in step 2.
8. Adjust the top-of-form position (the position where the printer
will start printing) using the micro adjust feature as described
in "Adjusting the Top-of-Form Position" on page 2-37. The
printer will start printing at the current position without
advancing the paper.
Caution
c
T
T
9. Attach the paper guide. Then slide the edge guides to the
middle of the paper guide.
10. Attach the printer cover and close the paper guide cover.
Note:
Always close the printer cover before printing. The printer does not
print when the cover is open.
2-32
Printing on Continuous Paper
Never use the knob to remove slack in the paper or to
adjust the top-of-form position; this may damage the
printer or cause it to lose the top-of-form position.
Always remove any slack from the paper; otherwise
print quality may be reduced.