Adjusting The Top-Of-Form Position - Epson FX-2180 User Manual

Adjusting the Top-of-Form Position

The top-of-form position is the position on the page where the
printer will start printing. If your printing appears too high or
low on the page, you can use the micro adjust feature to adjust
the top-of-form position as described below.
Caution:
c
Never use the knob to adjust the top-of-form position; this may
damage the printer or cause it to lose the top-of-form position.
Note:
R
Your top-of-form position setting remains in effect until you
change it, even if you turn off the printer.
R
The top margin setting made in some application software
overrides the top-of-form position setting you make with the
micro adjust feature. If necessary, adjust the top-of-form position
using your software.
1. Make sure the printer is turned on.
2. If necessary, load paper as described earlier in this chapter. If
you load paper onto a push tractor, press the Load/Eject
button to advance the paper to the current top-of-form
position.
3. Lift the printer cover up and off the printer.
Hold down the Pause button for about three seconds. The Pause
4.
light starts flashing and the printer enters the micro adjust
mode.
Printing on Continuous Paper
2
2-37