Table of Contents
Advertisement
Step 1.
Position the front system fan where the four tabs are aligned with the corresponding holes in the
mounting area. In addition, ensure that the two posts of the front system fan are aligned with the
corresponding holes in the inner side of the chassis; then, carefully slide the front system fan into
the chassis until it snaps into position.
Note: When installing the front system fan into the chassis, make sure the cables do not interfere
with the two posts and the fan is firmly seated.
Figure 48. Front system fan installation
Step 2.
Connect the front system fan power cable to the Fan 1 or Fan 4 connector on the system board.
See "System board components" on page 27 and "Fan power cable" on page 31.
Install a hot-swap drive
Use this information to install a hot-swap drive.
"Read the
installation
Guidelines" on
page 54
The following notes describe the type of drives that your server supports and other information that you must
consider when you install a drive.
• Depending on your server models, your server supports the following drive types:
– Solid-state drives
– SAS/SATA drives
For a complete list of supported optional devices for the server, see:
serverproven/index.shtml
ThinkSystem ST250 Setup Guide
68
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 55
https://static.lenovo.com/us/en/
Advertisement
Table of Contents
