Table of Contents
Advertisement
Figure 56. EMI shield removal in optical drive bay
Step 5.
Insert the optical drive into the optical drive bay and slide it in until it is obstructed.
Step 6.
Gently pull the metal tab on the slide of the chassis and slide the optical drive slightly. Release the
tab and keep sliding the optical drive until it snaps into position.
Figure 57. Optical drive installation
Step 7.
Connect the power cable and the signal cable to the rear of the optical drive. See "Cable routing:
optical drive" on page 34.
ThinkSystem ST250 Setup Guide
78
Advertisement
Table of Contents
