Table of Contents
Advertisement
Figure 27. Cable routing for server models with four 3.5-inch hot-swap drives (hardware RAID)
Cable
Power cable for backplane 1
1
SAS signal cable for backplane 1
2
Server models with eight 3.5-inch hot-swap drives (hardware RAID)
Use this section to understand the cable routing for server models with eight 3.5-inch hot-swap drives
(hardware RAID).
Note: Ensure that all cables are routed through the correct cable clips.
ThinkSystem ST250 Setup Guide
42
From
Power connector on backplane 1
SAS connector on backplane 1
To
Backplane 1 power connector on the
system board
An available connector on the RAID
adapter
Advertisement
Table of Contents
