Rear view of server models with a fixed power
supply
Figure 11. Rear view
Table 5. Components on the rear of server models with a fixed power supply or two hot-swap power supplies
Power cord connector
1
VGA connector
2
Serial connector
3
Dedicated XClarity Controller (XCC) network connector
4
Ethernet 1 connector (shared with XCC network port)
5
1
Power cord connector
Connect the power cord to this component.
2
VGA connector
Used to attach a VGA-compatible video device, such as a VGA monitor.
3
Serial connector
Connect a 9-pin serial device to this connector. The serial port is shared with the XCC. The XCC can take
control of the shared serial port to redirect serial traffic, using Serial over LAN (SOL).
Rear view of server models with two hot-swap
power supplies
Ethernet 2 connector
6
USB 3.1 Gen 2 connector
7
USB 3.1 Gen 1 connector
8
PCIe slots
9
Chapter 2
.
Server components
23